Last Updated: November 25, 2018 (Refresh Now)
Solder Sucker desoldering pump
Last Updated: November 25, 2018 (Refresh Now)
6.1
SCORE
/10
Total Reviews
987
Old Reviews
872
Unverified
45
Spam Test
!
Review Analysis - 70 recent, verified reviews
Detailed Mode
Build Quality
19tip, solder, spring, solder sucker, suction
+21%
-79%
" ... Does NOT STAY TOGETHER, junk plastic meets metal threads and does NOT stay together. ... "
" ... This solder sucker is the worst one I have EVER used. ... After a solid hour of use, it breaks. ... "
" ... However, the tip/cap is made out of delrin and screws into the aluminum body. ... "
" ... I opened the package and it fell apart, i had to supper glue the top half to the bottom half ... "
" ... I was testing it to just see how it worked and it popped apart. ... I then try to fix the pump and find that i can't there is a spring inside that is completely bent. ... "
" ... Plastic top and bottom so does not stay on the device. ... Pops off and had to use electrical tape on both ends to prevent the top or bottom plastic from popping off the metal tubing. ... "
" ... Hunk of junk, you press it down to get it ready to suck and the enitre body comes apart. ... The threading sucks, and is too weak to hold the spring. ... "
" ... When I went to use the solder sucker the end, where it was screwed on, fell off. ... I had to wrap electrical tape around it to hold it in place. ... The threads were bad that held the end on where you clean out the old solder. ... "
Fit
10threads, spring, together, suction, stay together
+20%
-80%
" ... Does NOT STAY TOGETHER, junk plastic meets metal threads and does NOT stay together. ... "
" ... The back completely popped off when I was using it. ... "
" ... Plastic top and bottom so does not stay on the device. ... Pops off and had to use electrical tape on both ends to prevent the top or bottom plastic from popping off the metal tubing. ... "
" ... The threading sucks, and is too weak to hold the spring. ... "
" ... I had to wrap electrical tape around it to hold it in place. ... "
" ... This also ruins the suction because it can't hold the tip to the body tightly enough to let the o-ring create a seal. ... I'll give it two stars because the spring mechanism works well, and after I wrapped plumber's tape around the threads of the removable tip to increase the diameter of the area and create a seal, it's now functional with 100% fewer eyes put out. ... "
Review Spam Test
In order to keep our review summaries as accurate as possible, we aggressively detect fake reviews. We use various signals to detect unnatural patterns and will gradually expose them here.
Spam Test could not be completed. Click here to retry.
Specifications
No specs available.
Recommendations
...